Always disconnect the battery before servicing high current fuses. Lift tire on one side and remove the retainer from the spare tire. If you have not pulled out enough webbing to reach, allow the webbing to fully retract before attempting to pull it out again and repeat steps 2 through 4. Open liftgate and remove the carpeted floor lid and jack cover. Do not hang any type of accessory or accessory bracket from the plug. Ford recommends the use of a child safety seat having a top tether strap.
You can override fan speed at any time. This will also assist in transmission cooling. To obtain reimbursement information, U. Turn the key full travel toward the front of the vehicle to make sure the alarm disarms. Hold the control to move through the frequencies quickly. Speaker fade adjust Speaker sound can be adjusted between the front and rear speakers. Ensure that the cables are clear of fan blades, belts, moving parts of both engines, or any fuel delivery system parts.
Press down on the top outboard area of the seatback until a click is heard. The purpose of these head restraints is to help limit head motion in the event of a rear collision. This program is separate from the New Vehicle Limited Warranty. In normal operation, automotive brake systems may emit occasional or intermittent squeal or groan noises when the brakes are applied. Push and hold for a longer wash up to ten seconds. Press the 4x4 Auto or the 4x4 High button. Window lock The window lock feature allows only the driver to operate the power windows.
If you must use a forward-facing child seat in the front seat, move the seat all the way back. Do not park your vehicle in Neutral, it may move unexpectedly and injure someone. All vehicles are equipped with a cargo lamp, which is located overhead in the rear cargo area and above the the third row seat if equipped. Follow the same steps to replace either bulb: 1. Check the fuel system for leaks.
Refer to Engine coolant in the Maintenance and care chapter. After three driving cycles without these or any other temporary malfunctions present, the light should turn off. Be sure the belt webbing is not twisted. However, in some climates, using snow tires or traction devices may be necessary. Speaker balance adjust Speaker sound distribution can be adjusted between the right and left speakers. The purpose of these head restraints is to help limit head motion in the event of a rear collision. Ford may change the contents without notice and without incurring obligation.
Twist a thin coin between the two halves of the transmitter near the key ring. Not intended for use on dry pavement. A correct zone setting will eliminate this error. To fasten, grasp the tongue, and with a continuous motion, pull out enough webbing to buckle the tongue into the correct buckle. Ensure that vent caps are tight and level. Follow the same steps to replace either bulb: To remove the headlamp bulb: 1.
Refer to Adding engine coolant, in the Maintenance and Care chapter. Make sure that the mat does not interfere with the operation of the accelerator or the brake pedal. The Safety Canopy is mounted to the roof side-rail sheet metal, behind the headliner, above the first and second row seats. Do not drive over the crest of a hill without seeing what conditions are on the other side. Add enough fluid through the filler opening so that the fluid level is at the bottom of the opening.
Make sure the gearshift lever is securely latched in P Park. If it enters the red section, the engine is overheating. If the concentration of coolant falls below 40% or above 60%, the engine parts could become damaged or not work properly. It can be used to clear ice or fog from the windshield. However, for severe usage or in high temperature climates, check the battery electrolyte level.