Mac 700 wash user manual. MAC 700 Wash user manual 2019-02-10

Mac 700 wash user manual Rating: 6,8/10 1018 reviews

Mac 700 Wash User Manual PDF Book

mac 700 wash user manual

Values much below 100 indicate interference, poor connections, or other problems with the serial data link that are the most common cause of control problems. Never exceed the lamp s average service life by more than 10%. Center the hot spot vertically using the top Allen-head adjustment screw A in the center of the rear plate. Set the offset to zero and then increase it until a clearly defined M shape with minimal light spill is projected onto the paper. This highly efficient double-ended short-arc source provides a color temperature of 7500 K, a color rendering index greater than 85, an average service life of 750 hours and hot restrike. The schedule depends heavily on the operating environment. Apply power but do not strike the lamp until zoom has been calibrated.

Next

SOLVED: Mcculloch pro mac 700 manual

mac 700 wash user manual

There is no connection to pins 4 and 5. It is essential to follow the cleaning guidelines given later in this section. Install only genuine Martin parts. Fine control of the dimmer is available on channel 3 in extended mode. When powered up, check lamp alignment as described on page 9.

Next

MAC 700 Wash user manual

mac 700 wash user manual

Refrigerator ice door insulation Part : 5303917276. Replace the top head cover and release the tilt lock before applying power. Disconnect the fixture from power and allow to cool for at least 45 minutes before removing any cover. An excessive hot-spot will damage optical components. It is not for household use.

Next

MAC 700 Wash user manual

mac 700 wash user manual

. Ensure that this product is recycled at the end of its life. Zoom On channel 10 16 in extended mode , the separate zoom lens varies the one-tenth peak beam angle from 12. Never connect more than 1 data input and 1 data output. Refer any service operation not described in this manual to a qualified technician. The pin-out on all sockets is pin 1 to shield, pin 2 to cold - , and pin 3 to hot +.

Next

MAC 700 Wash user manual

mac 700 wash user manual

The clear quartz bulb must be clean and free of any oils from your fingers. Disconnect the fixture from power and allow it to cool for 45 minutes. Snap dimming 0-100% or 100-0% is instant. If the shutter is closed for longer than 10 seconds while the lamp is in 700 W mode, lamp power is automatically switched to 400 W. Keep all combustible materials for example fabric, wood, paper at least 0. Select one fixture to be the reference fixture.

Next

SOLVED: Mcculloch pro mac 700 manual

mac 700 wash user manual

If a discharge lamp explodes in a confined area, evacuate the area and ventilate it thoroughly. Figure 6: Clamp bracket positions and safety wire attachment point Warning! Remove the front lens by twisting one quarter-turn counter-clockwise. Replace the lamp immediately if it is deformed or in any way defective. Effect movement may be rough and unpredictable if controller fade times are combined with vector speed values. Press the filter forwards slightly A to release it and then grasp it by the edges and remove it B. I also included the parts diagram. The illustration shows the filter positions as seen from the lamp side.

Next

SOLVED: Mcculloch pro mac 700 manual

mac 700 wash user manual

Remove the main fuseholder, which is located beneath the power switch. Use only power cable specified as extra hard usage Do not attempt to bypass fuses. Push the assembly straight in until it seats, making sure the lamp passes through the reflector opening. Fine control of zoom is available on channel 17 in extended mode. Do not attempt to bypass thermostatic switches or fuses.

Next

SOLVED: Mcculloch pro mac 700 manual

mac 700 wash user manual

Five additional stock patterns are available as accessories from Martin dealers. To connect the data link 3-pin to 3-pin phase-reversing adaptor Male Female 1. Do not illuminate surfaces within 1. Fine control of the color wheel is available on channel 13 in extended mode. To clamp the fixture on a truss 1.

Next

MARTIN MAC 700 WASH USER MANUAL Pdf Download.

mac 700 wash user manual

Block access below the work area and work from a stable platform whenever installing, servicing or moving the fixture. Install only an approved lamp. The color wheel can scroll continuously allowing split colors or in full-color steps. The command must be sent for 5 seconds. The shutter opens when the movement is complete.

Next